Oregon PowerScan Handheld Laser Scanner - Manual (Page 14)

8
PowerScan
®
Scanner
3. Scan the END label at the bottom of the page to save any new
settings and exit Programming Mode. The scanner will sound
a beep and reset upon exiting Programming Mode, and the
green LED will return to its usual state (on steady or off).
The scanner will not exit Programming Mode unless the END
bar code is scanned or power is disconnected. Disconnecting
power during Programming Mode, before scanning the END
label, will cause all new settings to be ignored. On power-up,
the scanner will return to previous settings.
4. Maintain a good record of all changes made to ensure that you
know if the original factory settings have been changed.
NOTE
It is recommended that programming ses-
sions be limited to one feature at a time.
Should you make a mistake in the program-
ming sequence, it can be difficult to discover
where an error has been made if several fea-
tures are programmed at once. Additionally, it
can be confusing to determine which features
may or may not have been successfully set
following such a session.