Heat & Glo Fireplace ST-38HV-AU - Manual (Page 24)

24
OPERATING CAUTIONS
• THIS APPLIANCE MAY EXHIBIT A SLIGHT CAR-
BON DEPOSITION.
• DO NOT PLACE ARTICLES ON OR AGAINST THIS
APPLIANCE.
• DO NOT USE OR STORE FLAMMABLE MATERI-
ALS NEAR THIS APPLIANCE.
• DO NOT SPRAY AEROSOLS IN THE VICINITY OF
THIS APPLIANCE WHILE IT IS IN OPERATION.
• THE DRESS GUARD IS FITTED TO THIS APPLI-
ANCE TO REDUCE THE RISK OF FIRE OR INJURY
FROM BURNS AND NO PART OF IT SHOULD BE
PERMANENTLY REMOVED. FOR PROTECTION
OF YOUNG CHILDREN OR THE INFIRM, A SEC-
ONDARY GUARD IS REQUIRED.
• THE DRESS GUARD MUST BE IN PLACE AND
SEALED AND THE FIXED MESH TRIM ASSEM-
BLY MUST BE IN PLACE ON THE HEATER BE-
FORE THE UNIT CAN BE PLACED INTO SAFE OP-
ERATION.
• DO NOT USE THIS APPLIANCE IF ANY PART HAS
BEEN UNDER WATER. IMMEDIATELY CALL A
QUALIFIED SERVICE TECHNICIAN TO INSPECT
THE UNIT AND TO REPLACE ANY PART OF THE
CONTROL SYSTEM AND ANY GAS CONTROL
WHICH HAS BEEN UNDER WATER.
• DO NOT OPERATE THIS APPLIANCE WITH THE
GLASS DOOR REMOVED, CRACKED, OR BRO-
KEN. REPLACEMENT OF THE GLASS DOOR
SHOULD BE DONE BY A LICENSED OR QUALI-
FIED PERSON. DO NOT STRIKE OR SLAM THE
GLASS DOOR.
• THE GLASS DOOR ASSEMBLY SHALL ONLY BE
REPLACED AS A COMPLETE UNIT AS SUPPLIED
BY THE GAS HEATER MANUFACTURER. NO SUB-
STITUTE MATERIALS MAY BE USED.
2.1 SAFETY & LIGHTING INFORMATION
Follow Section 2.2 SAFETY INFORMATION and 2.3
LIGHTING INSTRUCTIONS to light the appliance.
By design, the flame pattern will not be identical from
unit to unit. Additionally, flame pattern may vary de-
pending on installation type and weather conditions.
NOTE: THE TIPS OF THE FLAMES SHOULD
NEVER HIT THE TOP OF THE FIREBOX.
If the flame height is higher than this, adjustments must
be made to prevent overheating the gasket and glass.
Please contact your dealer or a qualified service per-
son to replace the injector or adjust the valve.
These gas models have gas control valves which allow
you to increase or decrease the height of the main
burner flames. Rotate the adjustment knobs clockwise
to "HI" to increase the flame height and counterclock-
wise to "LO" to decrease the flame height.
FIGURE 28
BLACK S2
ON
OFF
ON/OFF
SWITCH WHITE T2
RED T1
THERMOPILE
GAS VALUE
BLACK S1
3/16” PIGGYBACK CONNECTOR
THERMOCOUPLE
REMOTE SWITCH
PIGTAIL
OPTIONAL WALL SWITCH,
THERMOSTAT OR REMOTE