FUJITSU V810 - Manual (Page 44)

System expansions
36 A26361-K680-Z122-1-7619, Edition 1
a
1
2
► Push the rear slot cover plate into the slot (1). Ensure that the point of the cover engages on
the outside of the casing.
► Put the clip on. Make sure that the pin (a) is inserted into the screw hole.
► Press the clip in the direction of the arrow (2). Make sure that the clip engages when released.
► Close the casing (see "Closing the casing" chapter).
i
If you have installed or removed a PCI board, please check the relevant PCI slot settings
in the BIOS Setup . If necessary, change the settings. Further information is provided in the
PCI board documentation.