FUJITSU V810 - Manual (Page 55)

System expansions
A26361-K680-Z122-1-7619, Edition 1 47
Removing a hard disk drive
► Disconnect all cables connected to the drive (data cable, power supply cable).
1
1
2
► Press the EasyChange rails in the direction of the arrows (1).
► Pull the hard disk drive out of the carrier (2).
► Pull the EasyChange rails off the hard disk
drive.
► If necessary, make the required settings on
the remaining hard disk drive.
► Attach the front panel (see "Attaching the front panel" chapter).
► Close the casing (see "Closing the casing" chapter).
i
It may be necessary to modify the entry for the drive in the BIOS Setup .