Furuno MU-17OC - Manual (Page 10)

3
Desktop mounting
The display unit can be mounted on a desktop, using the optional bracket kit
(Type: MU-170C Hanger, Code No.: 000-153-819).
Contents of bracket kit
Name Qty
Hanger L 1
Hanger R 1
Pole 1
Hole plug
2
Hex bolt (M10x30) 2
Flat washer (M10) 2
Spring washer (M10) 2
Hex bolt (M5x25) 4
Flat washer (M5) 4
Spring washer (M5) 4
1. Assemble two hangers and pole with two hex bolts (M10x30), spring washers and flat
washers, and cover holes for hex bolts with the hole plugs.
2. Fix the above assembly to the mounting location with four hex bolts (M10, dockyard
supply).
Note: Do not mount the unit where the
exhaust or intake vent may be
obstructed.
3. Remove the hard cover and four cosmetic
caps from the unit.
4. Set the display unit to the assembled
hanger, and fasten it with four hex bolts (M5x25), spring washers and flat washers.
5. Attach the cosmetic caps and the hard cover to the display unit.
Hanger L
M10 bolts for fixing
(Dockyard supply)
Pole
Hanger R
Flat washer (M10)
Spring washer (M10)
Hex bolt
(M10x30)
Hole plug
To remove this cosmetic cap,
insert fingernail in groove.
Desktop mounting
Hex bolt (M5x25)
Spring washer (M5)
Flat washer (M5)
Intake vent Exhaust vent
Display unit (rear view)