Furuno MU-17OC - Manual (Page 9)

2
Flush mounting
See the outline drawing of this manual for mounting dimensions.
CAUTION
Hold the hard cover and display unit
together when lifting the display unit.
The display unit may fall out if only the
hard cover is held.
1. Remove the hard cover and four cosmetic caps from the unit.
2. Using the paper template supplied, make a cutout in the mounting location.
3. Set the display unit to the cutout, and fasten it with four self-tapping screws (5x40,
supplied as accessories).
Note: Hex head bolts may also be used to fasten the display unit. However, their
lengths must project 10 mm from the wall.
Waterproofing: IP20 Waterproofing: IP56, CFR46
30 98
Cosmetic cap
Minimum: 50
Flush mounting
4. Attach the cosmetic caps and the hard cover to the display unit.