Furuno MU-17OC - Manual (Page 22)

15
4.2 Adjusting Display Brilliance
The display brilliance can be adjusted as follows.
1. Press
the BRILL key on the display unit to show the BRILL adjustment window.
This window disappears if there is no operation for five seconds.
BRILL adjustment window
2. Press the ◄ or ► key to adjust the brilliance (available range: 1 to 50).
You can also adjust brilliance by pressing the BRILL key continuously.
3. Press the ▲ or ▼ key to close the window.
Note1: Uneven brilliance may result if the brilliance is too low. This is normal with an LCD;
it is not a symptom of malfunction. If the equipment is turned off with minimum
brilliance, the screen will be blank at the next power up. In this case, press the
BRILL
key continuously.
Note2:
When using the DVI input signal with the FAR-21x7 series and EXT BRILL CTRL is
turned on in the MU-170C’s system menu, brilliance can be adjusted from the
FAR-21x7’s control unit. For RGB1, RGB2, VIDEO1, VIDEO2 or VIDEO3 signal
input, the brilliance cannot be adjusted from the control unit. In this case use the
BRILL
key on the MU-170C or BRILL keys on the remote controller.
BRILL 50