Furuno MU-17OC - Manual (Page 23)

16
4.3 Choosing Source for Main Picture
Choose the signal to display on the entire screen as follows:
1. Press the DISP key to show the DISP selection window.
This window disappears if there is no operation for five seconds.
DISP selection window
2. Press the ▲ or ▼ key to select a signal.
You can also select the signal by pressing the DISP key continuously.
RGB1-2:
The signal from the chosen RGB port is displayed.
DVI: The signal from the DVI port is displayed.
VIDEO1-3: The external video from the chosen VIDEO port is displayed on the
entire
screen.
3. Press the ◄ or ► key to close the window.
The window disappears if there is no operation within five seconds.
Note: The name of the selected signal appears at the right top corner for five seconds after
the DISP selection window is erased.
RGB1
RGB2
DVI
VIDEO1
VIDEO2
VIDEO3