FARGO electronic FOTO 970627-510489-(04) - Manual (Page 11)

Using FotoFUN! for Windows 8
Section 4: Using FotoFUN! for Windows
A. CONNECTING FotoFUN! TO YOUR COMPUTER
FotoFUN! is designed to be used with nearly any IBM-PC ¨ or
compatible running Windows 3.1x or Windows 95. For best
performance, a minimum of a 486/66 computer with 8Mb of
RAM or higher is recommended.
The printer is equipped with a standard 8-bit Centronics-type
parallel port. This port is the means through which FotoFUN!
receives data from your computer. To connect FotoFUN! to your
computer, simply obtain a standard computer to printer parallel
cable, and refer to the following steps:
NOTE You may experience printing problems if your computer’s parallel port
mode is set to ECP. For best results, set your computer’s parallel port
to the standard “Printer Port” setting. Refer to your computer’s
system documentation for instructions on checking and/or changing the
parallel port mode.
1. Connect the Centronics-type parallel side of the cable to the
printer. Snap the fastening clips into place.
510489 FotoFUN! 7/29/98 3:26 PM Page 9