FARGO electronic FOTO 970627-510489-(04) - Manual (Page 20)

17 Using FotoFUN! for Macintosh
Section 5: Using FotoFUN! for Macintosh
A. CONNECTING FotoFUN! TO YOUR COMPUTER
FotoFUN! is designed to be used with any Apple Macintosh
supporting Color QuickDrawª and running system software
7.0 or higher. For best performance, a Macintosh with a 68040
processor and 8Mb of RAM (or higher) or a PowerMac with
8Mb of RAM (or higher) is recommended. The FotoFUN!
printer driver is accelerated for use with a PowerMac.
FotoFUN! cannot be used with the Macintosh Plus, SE, or
Classic since these models do not support Color QuickDraw.
The printer is equipped with a high-speed serial port. This
port is the means through which FotoFUN! receives data from
your computer. This port is not AppleTalkª compatible. To
connect FotoFUN! to your computer, simply obtain a standard
serial cable with an 8 pin mini-DIN connection on each end,
and refer to the following steps:
1. Connect one end of the serial cable to the printer.
2. Connect the other end of the cable to either the Printer or
Modem port of your Macintosh.
510489 FotoFUN! 7/29/98 3:26 PM Page 18