Fortinet FortiAnalyzer 3.0 MR7 - Manual (Page 130)

FortiAnalyzer Version 3.0 MR7 Administration Guide
126 05-30007-0082-20080908
Configuring reports Reports
When configuring the FortiAnalyzer unit to email a report, you must first configure
the FortiAnalyzer unit to connect to an email server. For more information, see
“Configuring alerts by email server” on page 135 .
If HTML reports are sent to a user that has an email client without supported
HTML, the HTML code for the reports will display in the message body.
You cannot delete a report output configuration if it is already being used in
another report.
Figure 7: Output template
To configure the output for a report
1 Go to Report > Config > Output.
2 Select Create New.
3 Enter and/or select the appropriate information for the fields and check boxes for
the following:
E-Mail Destination The route the email will take when sent, in the format,
<recipient_email address> (from <sender_email address> through
<email server>).
FTP/SFTP/SCP Server
IP The type of server that the report will be uploaded to in the format,
<ipv4>(typeofserver). For example, 10.10.20.15(FTP).
Action Select Edit to view or modify the report output.
Select Delete to remove the report output.
Name Enter a name for the report. This name only concerns the report
output configuration that you are configuring for your report., not
the report itself.
Description Enter a description for the report. This is optional.