Fuji Bikes Cyber-Relax AS-888 - Manual (Page 31)

When changing the COURSE on the way
30
FOOT STRETCH
WHOLE BODY
WAVELET STRONG
MIN
(Change from AUTO COURSE
→ Select function)
1. Open the lid of remote controller when the AUTO
COURSE (for example, the WHOLE BODY course) is
displayed.
Just opening the lid causes no change on the display and
the massage movement.
2. If you push the “WHOLE
⋅ PART” button and then one of
the “MASSAGE”, “STRETCH” or “3D” and the “AIR”
button, the movements of selected functions will start.
(For the movement of each function, refer to the description of
each function.)
At this time, the timer count is reset and starts the full count of 15
minutes. (However, it will stop as the maximum 30 minutes elapse
consecutively after the start of massage.)
(Change from Select function
→ AUTO COURSE)
1. Close the lid of remote controller in the state that the
select function (for example, STRETCH TAPPING) is
displayed.
2. Select a desired course from the AUTO COURSE buttons
on the lid.
3. The AUTO COURSE will start.
At this time, the timer count is reset and starts the full count
of 15 minutes. (However, it will stop as the maximum 30
minutes elapse consecutively after the start of massage.)
ADJUST
WHOLE
⋅ PART
MASSAGE
STRONG
3D
AIR
STRENGTH
GENTLE
SPEED
WIDTH
AUTO
WHOLE
SHOLDER
WAIST
7 MIN
STRENGTH
ADJUST
SHOLDER
UP
AIR
DOWN
AIR
STRETCH
SHOULDER AIR:
STRONG
MIN
sp: st: w:
POINT STRETCH TAPPING
COURSE
▲ UP
▼DOWN