Fuji Bikes Cyber-Relax AS-888 - Manual (Page 33)

When trouble is suspected
32
Phenomenon Inspection Point Remedy Reference Page
Check the power cord plug for
disconnection. Insert the plug in the receptacle
securely. 14 Unable to
recline
Check the back rest for
interference with the wall or
other obstruction. Move the chair to clear from
obstruction. 13
Service
receptacle is
dead. Check the power supply fuse
for blowing. Replace the fuse (3A). 8
Request:
When the LCD of remote controller is showing “Turn off, turn on,
then restart.”, turn OFF and on again the power supply as
instructed.
* If the above action does not improve the situation, turn OFF the power switch, disconnect the power
cord plug and consult your dealer or us.
Maintenance
Main unit: Cover cloth, back pad, pillow and seat pad (vinyl chloride leather)
Request: To clean the leather, wipe with rags impregnated with neutral detergent. Wipe again with
rags moistened with water to remove the detergent and then dry naturally. (Refrain from
using too much detergent not to damage the leather.) Use dry rags over the painted surface.
Request: Keep the equipment clean always and store it at a safe place free from excessive
temperatures, humidity, dirt, or others.
Remove the power cord plug from the
receptacle before inspection or maintenance.
It is very dangerous to handle the plug with
wet hands. It could cause electrical shock or
injury.
Do not use benzene, thinner, or
anything containing acetate for
cleaning . It could cause electrical
shock or ignition.
* Seat pad is secured on the seat with magic
tapes. Separate the tapes to remove it.
Turn off,
turn on,
then restart.
CAUTION
CAUTION