Frymaster Heated Landing Zone HLZ 22 - Manual (Page 14)

Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
318-865-1711 FAX 318-862-2394
Printed in the United States Service Hotline Page 12
1-800-24-FRYER
g. Go to step 9.3.2 and reassemble the air delivery tower.
9.7 Accessing the Plate and Air Heaters:
a. Use the following method to remove the
plate heater assembly or access the
compartment underneath the plate
heater.
b. Remove the cowl assembly per steps
9.3.
c. Then remove the air delivery assembly
following steps in 9.5.
d. Insert a thin, sharp knife, i.e.
Exacto-type, between the heater
plate and the HLZ chassis.
Carefully cut the silicon adhesive
between the heater plate and the
chassis.
e. Lift the heater plate by prying up
one end of the heater plate away
from the HLZ chassis. The plate is
held in place by an acrylic tape. It will be difficult to
break the bond between the heater plate and
chassis.
f. Remove acrylic tape from the heater plate and
frame to prevent rebounding while servicing.
g. When reinstalling the heater plate, apply new
acrylic tape to the HLZ chassis first. Then position the heater plate standing on
its side against the back air delivery assembly. The heater plate leads should be
coming off the “top” edge of the heater plate.
h. Once the heater plate is aligned properly with the HLZ chassis, gently lower the
heater plate until the plate end with the lead wires is approximately 2 inches from
the chassis. Feed the leads through the opening in the chassis wall.
i. Finish lowering the heater plate into place and connect the heater plate lead
wires.
After cutting the acrylic adhesive between the
heater plate and the HLZ chassis, use a
screwdriver to gently lift the heater plate.
Gently lift the heater plate, which may still be stuck to
the adhesive. Apply new acrylic tape to the chassis
before reinstalling the heater plate.
NOTE: A hot platen is
easier to remove. The
heat makes the
adhesive holding the
platen in place more
pliable.