FUJITSU MHD2032AT - Manual (Page 129)

Interface
5-58 C141-E050-02EN
Attribute ID Attribute name
12 Number of power-on-power-off times
13 to 198 (Reserved)
199 Ultra ATA CRC error rate
200 Write error rate
201 to 255 (Unique to vendor)
• Status Flag
Bit Meaning
0 If this bit 1, it indicates that if the attribute exceeds the threshold,
it is the attribute covered by the drive warranty.
1 If this bit is 1 (0), it indicates the attribute only updated by an on-
line test (off-line test).
2 If this bit 1, it indicates the attribute that represents performance.
3 If this bit 1, it indicates the attribute that represents an error rate.
4 If this bit 1, it indicates the attribute that represents the number of
occurrences.
5 If this bit 1, it indicates the attribute that can be collected/saved
even if the drive fault prediction function is disabled.
6 to 15 Reserve bit
• Current attribute value
The current attribute value is the normalized raw attribute data. The value
varies between 01h and 64h. The closer the value gets to 01h, the higher the
possibility of a failure. The device compares the attribute values with
thresholds. When the attribute values are larger than the thresholds, the
device is operating normally.
• Attribute value for the worst case so far
This is the worst attribute value among the attribute values collected to date.
This value indicates the state nearest to a failure so far.
• Raw attribute value
Raw attributes data is retained.
• Off-line data collection status
Bits 0 to 6: Indicates the situation of off-line data collection according to the
table below.