FUJITSU MHD2032AT - Manual (Page 51)

Theory of Device Operation
4-2 C141-E050-02EN
4.1 Outline
This chapter consists of two parts. First part (Section 4.2) explains mechanical
assemblies of the disk drive. Second part (Sections 4.3 through 4.7) explains a
servo information recorded in the disk drive and drive control method.
4.2 Subassemblies
The disk drive consists of a disk enclosure (DE) and printed circuit assembly
(PCA).
The DE contains all movable parts in the disk drive, including the disk, spindle,
actuator, read/write head, and air filter. For details, see Subsections 4.2.1 to 4.2.5.
The PCA contains the control circuits for the disk drive. The disk drive has one
PCA. For details, see Sections 4.3.
4.2.1 Disk
The DE contains disks with an outer diameter of 65 mm and an inner diameter of
20 mm. The MHC2040AT has three disks and MHC2032AT, MHD2032AT and
MHD2021AT have two disks.
The head contacts the disk each time the disk rotation stops; the life of the disk is
50,000 contacts or more. Servo data is recorded on top disk.
Servo data is recorded on each cylinder (total 60). Servo data written at factory is
read out by the read/write head. For servo data, see Section 4.7.
4.2.2 Head
Figure 4.1 shows the read/write head structures. MHC2040AT has 6 read/write
heads and MHC2032AT has 4 read/write heads. MHD2032AT has 4 read/write
heads and MHD2021AT has 3 read/write heads. These heads are raised from the
disk surface as the spindle motor the rated rotation speed.