FUJITSU MHE2064AT - Manual (Page 109)

Interface
5-34 C141-E057-02EN
Table 5.4 Information to be read by IDENTIFY DEVICE command (3 of 7)
Word Value Description
83 X’4008’ Support of command sets *11
84 X’4000’ Support of command sets/function
85 *12 Valid of command sets/function *12
86 *13 Valid of command sets/function *13
87 X’4000’ Default of command sets/function
88 X’xx07’ Ultra DMA transfer mode *14
89-127 X’0000’ Reserved
128 (Variable) Security status *15
129-159 X’0000’ Undefined
160-255 X’0000’ Reserved
Table 5.4 Information to be read by IDENTIFY DEVICE command (4 of 7)
*1 Word 0: General configuration
Bit 15: ATA device = 0, ATAPI device = 1
Bit 14-8: Undefined
Bit 7: Removable disk drive = 1
Bit 6: Fixed drive = 1
Bit 5-1: Undefined
Bit 0: Reserved
*2 Word 1, 3, 6, 60-61
MHE2064AT MHE2043AT MHF2043AT MHF2021AT
Word 01 X’3470’ X’22F0’ X’22F0’ X’1068’
Word 03 X’0F’ X’0F’ X’0F’ X’10’
Word 06 X’3F’ X’3F’ X’3F’ X’3F’
Word 60-01 X’80F7F0’ X’80F7F0’ X’80F7F0’ X’409980’
*3 Word 49: Capabilities
Bit 15-14: Reserved
Bit 13: Standby timer value. Factory default is 0.
Bit 12: Reserved
Bit 11: IORDY support 1=Supported
Bit 10: IORDY inhibition 0=Disable inhibition
Bit 9-0: Undefined