FUJITSU MHT2060BH - Manual (Page 110)

Interface
5-36 C141-E203-01EN
(7) READ VERIFY SECTOR(S) (X’40’ or X’41’)
This command operates similarly to the READ SECTOR(S) command except that
the data is not transferred to the host system.
After all requested sectors are verified, the device reports the status to the host
system.
Upon the completion of the command execution, the shadow block registers
contain the cylinder, head, and sector number of the last sector verified.
If an unrecoverable disk error occurs, the verify operation is terminated at the
sector where the error occurred. The shadow block registers contain the cylinder,
the head, and the sector addresses (in the CHS mode) or the logical block address
(in the LBA mode) of the sector where the error occurred. The Sector Count field
indicates the number of sectors that have not been verified.
•
Error reporting conditions
(1) A specified address exceeds the range where read operations are allowed
(ST = 51h, ER = 10h).
(2) The range where read operations are allowed will be exceeded by an address
during a read operation (ST = 51h, ER = 10h).
(3) An uncorrectable disk read error occurred (ST = 51h, ER = 40h).
(4) The sync byte indicating the beginning of a sector was not found
(ST = 51h, ER = 01h).
(5) A SATA communication error occurred (ST = 51h, ER = 01h).
(6) An error other than the above errors occurred (ST = 51h, ER = 04h).
At command issuance (Shadow Block Registers setting contents)
CM 0 1 0 0 0 0 0 R
DH x L x x HD No. / LBA
CH
CL
SN
SC
FR
Start cylinder No. [MSB] / LBA
Start cylinder No. [LSB] / LBA
Start sector No. / LBA [LSB]
Transfer sector count
xx