Furuno FM-4000 - Manual (Page 48)

FM-4000 Page 48
want to communicate on, then press the [ENT]
key.
6. Press the [ENT] key again to transmit the Group
call signal.
7. When the Group call signal is sent, the LCD
displays the information shown in the illustra-
tion at right.
8. After the Group call is transmitted, all the ra-
dios in the group switch to the designated chan-
nel.
9. Listen to the channel to make sure it is not busy,
then key the microphone and call the other ves-
sels you desire to communicate with.
Manual Calling
You may enter a Group MMSI number manually to contact a group whose
Group call number is not registered in the radio.
1. Press the [CALL(MENU)] key to show the “DSC DSC DSC DSC DSC
Call Menu Call Menu Call Menu Call Menu Call Menu .”
2. Turn the CHANNEL selector knob to select
“Group Group Group Group Group .” (To cancel, press the [CLR] key.)
3. Press the [ENT] key. The transceiver beeps
then the “Group Directory” appears.
4. Turn the CHANNEL selector knob to select
“Manual Manual Manual Manual Manual ,” then press the [ENT] key.
5. Enter the MMSI number (nine digits: first digit per-
manently set to “0”) which you want to contact, then
press the [ENT] key.
6. If you enter a wrong number in the MMSI number,
press the [H/L] key until the wrong number is se-
lected, then enter the correct number.
7. When you have finished entering the MMSI
number, press and hold the [ENT] key.
8. Turn the CHANNEL selector knob to select
“ Manual Manual Manual Manual Manual ,” then press the [ENT] key.
9. Turn the CHANNEL selector knob to select the op-
erating channel you want to communicate on, then
press the [ENT] key.
10. Press the [ENT] key again to transmit the Group
call signal.