Furuno FM-4000 - Manual (Page 60)

FM-4000 Page 60
12.7 SCAN TYPE
You can set the scan mode between “Memory Scan” and “Priority Scan.”
1. Press and hold down the [CALL(MENU)] key until
the “Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup ” menu appears.
2. Press the [ENT] key, then use the CHANNEL selec-
tor knob to select “SCAN Type SCAN Type SCAN Type SCAN Type SCAN Type .”
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select “Priority
Priority Priority Priority Priority
SCAN SCAN SCAN SCAN SCAN ” or “Memory SCAN Memory SCAN Memory SCAN Memory SCAN Memory SCAN .”
5. Press the [ENT] key to store the selected setting.
6. To exit this menu and return to radio operation mode,
press the [16/9] key.
12.8 SCAN RESUME TIME
Set the amount of time the FM-4000 waits after a transmission ends before
starting scanning.
1. Press and hold down the [CALL(MENU)] key until
the “Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup ” menu appears.
2. Press the [ENT] key, then use the CHANNEL selec-
tor knob to select “SCAN Resume SCAN Resume SCAN Resume SCAN Resume SCAN Resume .”
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select the de-
sired resume time. The resume time can be set to
“1sec
1sec 1sec 1sec 1sec ” through “5sec 5sec 5sec 5sec 5sec ,” or “Off Off Off Off Off .” In the “Off Off Off Off Off ” selection,
the scanning resumes after the other station stops
transmitting (carrier drops).
5. Press the [ENT] key to store the selected setting.
6. To exit this menu and return to radio operation mode,
press the [16/9] key.