Frymaster LOV BIGLA30 - Manual (Page 86)

BIGLA30 SERIES GEN II LOV™ GAS FRYER
APPENDIX B: JIB Preparation with Solid Shortening Option
1. Open right door of fryer and remove brace
in JIB cabinet.
2. Position melter in front of cabinet. Loosen
bracket on left side of melter, if necessary,
to ease placement in the cabinet.
3. Use the provided screws to attach the
melter to existing holes in the interior rails
of the fryer cabinet on both sides. See
figures 1 and 2.
4. On the back side of the melter, attach the
white two-pin connectors and plug in the
black connector to the outlet box shown in
figure 3.
5. Position the oil reservoir in the melter,
sliding the oil pickup tube into the female
receptacle. Position the front lid and the
front of the melter. See figure 4.
Figure 1: Position the melter in the cabinet and attach with
provided screws to the cabinet interior.
Figure 2: Position the melter.
Figure 4: The
assembled melter is
shown in position.
Orange button resets
system after a low oil
display.
Melter ON/OFF switch.
Figure 3: Attach the two-pin white connectors and plug the
black connector into the utility box as shown.