Frymaster BIELA14 - Manual (Page 18)

3–4
1. Open the cabinet and slide the JIB
from the cabinet (see Figure 5).
Figure 5
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 6).
Figure 6
3. With the replacement jug upright
remove the cap and foil seal (see
Figure 7).
Figure 7
4. Put the tube in the new full container (see Figure 8).
Figure 8
5. Slide the JIB onto the shelf inside the fryer cabinet (as
seen in Figure 5).
6. Press and hold the orange JIB reset switch until the
orange JIB LED is no longer illuminated (see Figure
9).
3.3.4 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix A located
at the rear of this manual.
WARNING:
Do not add HOT or
USED oil to a JIB.
Figure 9