Frymaster Dean 2424E - Manual (Page 23)

4-6
Reassembly
1. Place the two outer screens together and align their edges.
Ensure hole is on
same side as
handle.
Steps 1 and 2 - Stack outer screens
and insert edges into frame.
Step 3 - Insert grid between screens
after screens have been positioned in
frame.
Step 4 - Connect corner and pivot
frame over free edges of screens.
2. Insert the screens into one of the frame halves (it doesn’t matter which one). Ensure that the hole in the
top screen is on the same side of the frame as the handle.
3. Slip the grid between the screens so that the threaded fitting on the grid goes through the hole in the top
screen and the grid is centered between the edges of the screens.
4. Connect the other half of the frame at the corner opposite the handles and pivot the frame onto the free
edges of the screen.
5. Screw the standpipe onto the threaded fitting and hand tighten.