Frymaster Dean 2424E - Manual (Page 8)

2-1
FLATBOTTOM SERIES ELECTRIC FRYERS
CHAPTER 2: INSTALLATION INSTRUCTIONS
2.1 General
Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.
Any unauthorized alteration of this equipment will void the Dean warranty.
DANGER
Copper wire suitable for at least 167°F (75°C) must be used for power connections.
DANGER
The electrical power supply for this appliance must be the same as indicated on the
rating and serial number plate located on the inside of the fryer door.
DANGER
This appliance must be connected to the voltage and phase as specified on the
rating and serial number plate located on the inside of the fryer door.
DANGER
All wiring connections for this appliance must be made in accordance with the
wiring diagrams furnished with the equipment. Wiring diagrams are located on the
inside of the fryer door.
All installation and service on Dean equipment must be performed by qualified, certified, licensed,
and/or authorized installation or service personnel as defined in Section 1.4 of this manual. Service
may be obtained by contacting your local Factory Authorized Service Center.
This appliance must be kept free and clear of combustible material, except that it may be installed on
combustible floors.
A clearance of 6 inches (15cm) must be provided at both sides and back adjacent to combustible
construction. A minimum of 24 inches (61cm) should be provided at the front of the equipment for
servicing and proper operation.
WARNING
Do not block the area around the base or under the fryers.
2.2 After
Unpacking
Check the fryer(s) for visible damage; if damage is observed, do not refuse shipment. Refer to
Section 1.5 in Chapter 1 for the shipping damage claim procedure.