Frymaster 35 Series - Manual (Page 13)

1-9
a: Remove these screws
to release guard.
b: Bend this clip outward to
release thermopile.
c: Press down on top of thermopile,
forcing it out of the pilot bracket.
3. To replace only the thermopile in fryers with the current design pilot assembly (see illustration
below), use a 7 ⁄
16
-inch open-end wrench to loosen the thermopile, then unscrew it from the pilot
assembly. Screw the replacement into the pilot assembly and use a wrench to tighten it ¼-turn
past finger tight.
Ferrule on thermopile
unscrews from bottom of pilot.
3. To replace the complete pilot assembly of either design:
a. Disconnect the pilot tubing from the bottom of the pilot assembly.
b. Disconnect the thermopile lead(s) from the gas valve pilot coil.
c. Remove the screw(s) from the pilot-mounting bracket to release the pilot assembly.
d. Reverse steps a through c to install the replacement pilot assembly.
4. Reinstall the burner assembly by reversing steps 1-8 of Section 1.8.5.