Frymaster 35 Series - Manual (Page 7)

1-3
1.6 Adjusting the Pilot Flame
Non-CE Gas Valves
1. For Non-CE Gas Valves, remove the screw
from the pilot adjustment screw hole on the gas
valve.
2. Using a small, flat-tipped screwdriver, turn the
pilot adjustment screw counterclockwise to in-
crease the length of the flame or clockwise to
decrease the length of the flame. Adjust flame
to a length of 1 to 1½ inches (25 to 38mm).
3. Reinstall the pilot adjustment screw cap.
CE Gas Valves
Using a small, flat-tipped screwdriver, turn the pilot
adjustment screw counterclockwise to increase the
length of the flame or clockwise to decrease the
length of the flame. Adjust flame to a length of 25
to 38mm.
The pilot adjustment screw on the Non-CE
Honeywell valve is under this screw.
The pilot adjustment on the CE valve is here.
1.7 Calibrating the Thermostat Control
On Standard MJ35 Fryers
1. Fill the frypot to the lower OIL-LEVEL line with cooking oil. If solid shortening is used, it must
be tightly packed into the frypot before starting calibration procedure.
2. Light the pilot. (Refer to Chapter 3 of the Installation and Operation Manual, P/N 819-5776 for
detailed lighting instructions.)
3. Insert a good grade thermometer or pyrometer into the frypot, about one inch from the
thermostat.
4. Set the thermostat to 325°F (162°C).
5. Let the burner cycle on and off three times.