Fostex FD-8 - Manual (Page 33)

33
Handling Programs
1
(Turn on the power)
2
3
5, 6, 7
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
S M F
PGM
ABS
4
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
? SURE
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
? SURE
44.1kHz
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
PGM
Handling Programs
1. Turn on the power to the FD-8 and a connected SCSI
drive.
2. Insert a formatted disk into the SCSI drive.
The FD-8 displays [Initial..], [(SCSI drive name and ID
number)], [(Recording mode, such as [Normal])], then
the top of ABS Time Base (ABS 0).
The current Program is [PGM 01]. [#0001] is the default
name of PGM 01.
This chapter explains how to handle Programs. It covers the following topics:
1. Creating a new Program
2. Using a Program Change function
3. Deleting a Program
4. Editing a Program title
Creating a new Program
You can manage individual songs by setting multiple Programs on the disk as explained in the “Managing songs
by Program Change function” section of the “Before Starting” chapter. You can create up to 99 Programs can be
created as long as the disk space allows. When you format a disk, one Program will be automatically created.
Follow the steps below to create a new Program (in addition to the Program created on the disk during the format
operation).
6. Press the EXECUTE/YES key again.
A default title (#0002) appears on the display, with [#]
and [SURE?] flashing. This means that you can enter a
name for the new Program.
If you wish to name the Program with a unique title,
continue the steps below.
In either case, you can change the title later, as explained
in “Editing a Program title.”
5. Press the EXECUTE/YES key.
The FD-8 automatically enters [Title Edit ?] menu in SETUP
mode. You can enter a title for Program 2. ([t] and [?]
flash alternately.)
If you prefer the default name, press the EXIT/NO key.
4. Turn the JOG dial clockwise.
The question marks “?” of [New PGM ?] and [SURE?] flash.
This indication asks you if you wish to set a new Program
(Program 2).
3. While holding down the HOLD/> key, press the
STORE key.
[Select PGM] appears on the display briefly, then changes
to a flashing “01” ([#0001 of PGM 01) and [SURE?] flash.
([#0001] is the default name of PGM 01.)