Fostex FD-8 - Manual (Page 68)

Storing a Locate Point (Edit Point)
68
4
2 1, 2 3
2
1, 4
2 2 3
2
Editing and storing locate data
If you know the position of the desired locate point, follow the steps below.
1. Press the HOLD/> key while the FD-8 is stopped.
The currently-displayed time value (or bar/beat/clock
value) is captured and the FD-8 enters data edit mode.
2. Press the HOLD/> key, REWIND button, or the
F FWD button to move the flashing cursor on the
time value digit, and use the JOG dial to increase
or decrease the value.
3. Press the STORE key.
The STORE LED lights up.
4. Press the desired memory key.
The STORE LED turns off.
The input time value (or bar/beat/clock value) is stored
in the corresponding memory key.
Editing and storing data
You can recall data stored in the memory key, edit it, and store it. again
• Press the STORE key instead of the HOLD/> key in Step
1 above and omit Step 3 to speed operation.