Fostex FD-8 - Manual (Page 62)

Editing Tracks
62
Flashing
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
Executing Track Exchange
1. While the FD-8 is stopped, press the EDIT key
repeatedly until [TRK Exchg] flashes on the display.
Alternatively, you can press the EDIT key, then use the
JOG dial.
2. Press the EXECUTE/YES key.
The display shows the track selection.
The current display shows that you can swap eight-track
data between Real tracks 1-8 and Additional tracks 9-16.
If you wish to select other tracks, follow the steps below.
3. Select the tracks to swap data.
• Selecting Real tracks 1-8 and Additional tracks 17-24:
1. Press the HOLD/> key, the REWIND button, or
the F FWD button to move a flashing cursor on
[1-8] (left) to [9-16](right).
2. Turn the JOG dial to change flashing [9-16] to
flashing [17-24].
• Swapping mono track data between any two tracks
1. When [1-8] is flashing, turn the JOG dial.
Turning the JOG dial allows you to select a mono
track from [1], [2], [3], [4]........ [24] in the left column.
The right column continues a mono track.
For example, if you select [4] in the left column, the
display indicates [4<>1], meaning you can swap data
between tracks 4 and 1.
2. To select a number in the right column, press
the HOLD/> key, the REWIND button, or the F
FWD button to move the flashing cursor to the
right column, then use the JOG dial to select
the desired number.
* When you swap data between mono tracks, the
indications [4<>1] and [1<>4], for example, mean the
same thing — swapping data between tracks 1 and 4.
4. Press the EXECUTE/YES key.
[Exchange] lights up and the swapping operation is
completed immediately.
The FD-8 indicates [COMPLETED !], then returns to the
previous Time Base display.
Note: If you select the same tracks for swapping mono
track data, the setting is ignored. The FD-8 will indicate
[Select Err] for a short moment, then return to the previous
display.
* You cannot play data or check the REC END point on the
Additional tracks. To do so, you need to move the data to a
Real track.
If you load back-up data from the external DAT recorder,
adat machine, or backup SCSI drive, the data maintains the
same condition as when you previously saved it to DAT,
adat, or backup SCSI drive.
Flashing
Flashing
Flashing
Flashing
Flashing