Fostex FD-8 - Manual (Page 34)

34
Handling Programs
PGM 01 PGM 02 PGM 03 PGM 04 PGM 05 PGM 06 PGM 07 New PGM
You can select from PGM 03 up to
New PGM in this direction.
You can select up to PGM
01 in this direction.
2
3
1
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
? SURE
44.1kHz
7. When you finish entering the title, press the
EXECUTE/YES key.
Program 2 (PGM 02) and its title are set.
The display shows the ABS Time Base indication of the
Program.
<Important!>
• When you create a new Program by selecting the [New PGM ?]
menu, a new Program is created with an increment number.
That is, if only one Program exists and when you create a new
Program, it will be named Program 2.
If Programs 1-5 already exist, a new Program number will be 6.
• If there is insufficient recording space on the disk, you cannot
create the new Program. Each time you create a new Program,
the recordable area on the disk will decrease.
Using a Program Change function
If multiple Programs exist on the disk, you need to select a Program to record, play, or edit. This section describes
how to select a Program.
Note: You cannot use the Program Change function when the
FD-8 is in SETUP mode.
2. Turn the JOG dial to select the desired Program
number (flashing).
Rotating the JOG dial counter-clockwise decreases the
number, and rotating it clockwise increases the number.
If you turn the JOG dial clockwise all the way, [New PGM?]
will be selected. Select [New PGM ?] to create a new
Program as mentioned in the previous section “Creating
a new Program.”
For example, you can select one of seven Programs as
follows:
3. Press the EXECUTE/YES key.
The ABS Time Base indication for the selected Program
appears. In this way, you can be sure to select a Program
before you start working.
To enter a title:
• Turning the JOG dial will enter a character or number
at the location of the flashing cursor. You can enter up
to 16 characters, nine of which will appear on the display.
• To move the flashing cursor, press the HOLD/> key,
the REWIND button, or the F FWD button. The F FWD
button is the most convenient.
• You can enter the following characters and numbers:
1. When the FD-8 is stopped, press the STORE key
while holding down the HOLD/> key.
[Select PGM] appears on the display briefly, then changes
to a flashing “01” ([#0001 of PGM 01) and [SURE?] flash.
([#0001] is the default name of PGM 01.)