Fostex FD-8 - Manual (Page 76)

Preview Function
76
ABS
LOC S M H F SF
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
HOLD/> key
or
F FWD button
Time Base
ABS or MTC BAR/BEAT/CLK
Flash
LOC
BAR CLK
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
1
2, 4
3 5 3
SF H M S F
SF H M S F
CLK BAR
CLK BAR
1. Start previewing the sound by following the steps
described on the previous page.
2. Use the JOG dial to trim the position.
When previewing starts, the unit of JOG trimming flashes
on the screen. For example, value of SF (sub-frame) flashes
if ABS Time Base or MTC Time Base is selected. CLK (clock)
flashes if BAR/BEAT/CLK is selected.
The flashing value also indicates the position you can
trim.
Example: Time Base is ABS (value of SF flashes.)
Flash
Example: Time Base is BAR/BEAT/CLK (CLK flashes.)
3. To change the unit of trimming, press the HOLD/>
key, the REWIND button, or the F FWD button.
These buttons will change the trimming unit as follows:
4. Trim the position at the selected unit (digit).
5. Press the STOP button or the EXIT/NO key.
The trimmed locate point (edit point) data will be stored
in the corresponding memory key.
REWIND button
5