FUJITSU CG-311 SERIES - Manual (Page 13)

En-11
B. DC POWER CONNECTION
CAUTION:
¶Be sure to wire the power plug polarity
correctly.
¶Current consumption 390mA per camera
is required.
When selecting and connecting the power-supply
cord, take care concerning the following:
1
1 1 1 1 Current allowance of the power-supply cord.
2
2 2 2 2 Power supply voltage drop due to excessive
length or size of wire.
The rated power supply voltage of this camera
is +12VDC (+10.8 to +13.2VDC).
Be sure to use the camera within this range of
voltage.
Power supply connections are shown in Fig.6.
If a fuse is required, use a slow blow fuse con-
nected to the + terminal of the power supply
within 10cm (4inch) of the terminal.
CAUTION:
DC power supply must be marked with a CE symbol.
CAUTION:
If the power-supply cord is short-cir-
cuited, excessive current flows and is
extremely dangerous. The line fuse
must be required. (see Fig.6).
REAR PANEL
DC POWER
SUPPLY
Button
+12 V
GND
10cm (4.0 inch) MAX
DC 12 V
FUSE (slow blow)
1.0 A
Fig.6