Fostex MR-8HD/CD - Manual (Page 24)

MR-8HD/CD Supplementary manual
6) Use the [MENU/ENTER] knob to select the
desired WAV file and press the [MENU/ENTER]
knob.
The unit starts writing the file to the CD-R/RW
disc. Depending on the selected burning mode,
either of the following screens is shown.
While the unit is writing data to the disc,
"
Writing... " is popped up and " ACC " is flashing
on the screen.
Also the ACCESS indicator of the CD-R/RW drive
is flashing. Do not turn off the power or press
the eject switch of the drive while writing.
While writing data to the disc, any operational
keys of the MR-8HD/CD are disabled.
Now writing in the Track at once mode
Now writing in the Disk at once mode
<Note>: If the selected stereo WAV file is larger
than the available disc space of the current CD-
R/RW disc, the following message pops up and
you cannot start writing (you can dismiss the
message by pressing the [MENU/ENTER]
knob). Change the disc to another one with
enough space and carry out the same opera-
tion procedure.
When writing is completed, " Completed! " is
shown and the disc access stops.
Now writing in the
Track at once mode is completed
Now writing in the
Disk at once mode is completed
7) Press the [MENU/ENTER] knob.
The display returns to the USB HOST menu
screen, where "CD Burn " is highlighted.
When the disc is burned in the " Disk at once "
mode, it is automatically finalized after writing
is completed, and then ejected.
You can check the TOC information if desired.
See "Viewing the TOC information after finaliz-
ing" on page 27 for details.
When the disc is burned in the " Track at once "
mode, go to step 8 for finalizing the disc.
If you want to write more than one stereo WAV
file, repeat steps 4 through 6 above, and go to
step 8 for finalizing after writing all the desired
stereo WAV files.
You can check the TOC information any time
(both before and after finalizing). It is recom-
mended to check the remaining time (the re-
cordable time left) from the TOC information
whenever you write an additional stereo WAV
file (see "Viewing the TOC information" on page
26 for details).
8) Use the [MENU/ENTER] knob to select
"CD Finalize " and press the [MENU/ENTER]
knob.
The display now shows the confirmation screen
for finalizing, where "
[CANCEL] " is highlighted.
To cancel finalizing, highlight " [CANCEL] " and
press the [MENU/ENTER] knob.
To start finalizing, highlight " [EXECUTE] " and
press the [MENU/ENTER] knob.
24