Fostex MR-8HD/CD - Manual (Page 27)

MR-8HD/CD Supplementary manual
Viewing the TOC information after finalizing
The following assumes that a disc automatically finalized after " Disk at once " writing or a disc
finalized after " Track at once " writing is ejected from an external CD-R/RW drive, while the
display shows the CD-RW menu screen where " CD Finalize " is highlighted.
1) Close the ejected disc tray of the CD-R/RW
drive.
Push the front of the disc tray gently by hand.
The finalized disc is loaded.
Confirm that the "
CD Finalize " is highlighted
on the screen.
<Note>: When you close the tray, the drive
starts reading the disc and the access indica-
tor starts flashing. Therefore, do not carry out
the next operation until the drive stops access-
ing and the access indicator gets unlit.
2) Use the [MENU/ENTER] knob to select
"CD TOC " and press the [MENU/ENTER] knob.
The display shows " Please Wait... ", followed by
the TOC information, as with "Viewing the TOC
information before finalizing".
However, in this case, the remaining time is
shown as "
0h 00m 00s ", which means no more
tracks can be recorded to this finalized disc.
<Note>: When you burn multiple stereo WAV
files by "Track at once" and finalized or you burn
a stereo WAV file with multiple CUE points by
"Disk at once", the Track list screen looks like
the one below (the remaining time is shown as
"0h 00m 00s", of course).
3) After checking the TOC information, use the
[STOP] key to exit the MENU mode.
The display returns to the Home screen.
<Note>: You can also view the TOC of a com-
mercially available audio CD, as with an audio
CD you create using the MR-8HD/CD. (Note
that some commercially available audio CDs
may not show the TOC information.)
To do this, set an audio CD to the CD-R/RW
drive and carry out the same operation as de-
scribed above using the "USB HOST" menu in
the MENU mode.
Note that you can view only the playing time of
each track. You cannot view track titles.
27