Fujitsu Siemens Computers Fujitsu-Siemens PC - Manual (Page 52)

26
5. Enter the SSID in the "Network name (SSID)" field of the
device to which the connection is to be established. The
network names (SSID) can be obtained from the operator of
the receiver.
If the connection requires data encoding, activate the function
"Data encoding" and enter the required key in the "Network
key" field.
6. Click on "OK".
To connect two WLAN devices with each other in ad-hoc mode,
execute the specified steps for both devices and enter the same
SSID in this window. Activate the function "This is a computer-to-
computer network; wireless access points are not used". Click
on "OK".
This display will appear in the task bar next to the clock after
successful connection:
The signal strength displayed may vary due to external influences.
If you double click on the active connection (both screens in the
task bar), a window containing status information will appear. This
may differ depending on the network setup.