Fujitsu Siemens Computers Fujitsu-Siemens PC - Manual (Page 92)

66
Removing the slot cover
when slot cover screwed in place
• Loosen the screws on the slot cover in question and
remove the cover.
• Install the expansion module in accordance with the
manufacturer’s instructions.
• Fix the module in place with the screws from the slot cover.
• Follow the opening process in reverse to close the PC.
where slot cover pre-punched
• Insert a slot screwdriver in the crack visible from above
and turn inwards with gentle pressure to loosen the slot
cover, then pull off with a set of flat nose pliers. Any loose
metal cuttings are to be removed.
5. Install the expansion module in accordance with the module
manufacturer’s instructions.
6. Follow the opening process in reverse to close the PC.
7. Configure the BIOS setup if necessary (e.g. IRQ).
8. Install the required driver for the expansion module.
CAUTION! There is a risk of injury when installing and removing
modules due to sharp edges caused by pulling off the
slot cover.
• If you wish to remove the retrofitted module at a later
date, please close the resulting opening immediately
with a slot cover available from a specialist supplier.