Fujitsu Siemens Computers Fujitsu-Siemens PC - Manual (Page 91)

65
Closing the housing
Follow the opening process in reverse to close the PC.
i
Our tips and hints …
... on the SCALEO X
With the SCALEO
X, during assembly the locking mechanism
locks in place itself by pressing on the side wall, as shown in step 1.
CAUTION!
When closing the housing, ensure that the cover is
firmly and correctly in place. Check all locking
mechanisms such as screws, slides etc., to ensure
that these are mounted as they were by the factory
prior to you opening the housing.
5.3 Installing expansion modules
Take the following steps to install additional expansion modules:
1. Turn off the computer and all connected peripherals (monitor,
printer etc.). Disconnect these from the mains network by
removing the power cable from the socket.
2. Disconnect all connection cables (mouse, keyboard, printer,
modem etc.).
3. Open the housing, corresponding to your model, as described
in these instructions under "Opening the housing".
4. Remove the blank cover (slot cover, slot plate) on the rear of
the housing corresponding to the slot you wish to use.