FUJITSU NC14003-T256/L - Manual (Page 13)

12
6. Troubleshooting the installation
Checking the USB controller and network adapter
Select [Start] -> [Settings] -> [Control Panel], then double-click the [System] control panel icon.
Double-click the [Universal serial bus controller] item (toward the bottom of the device list).
Check that the “USB-USB Network Bridge Driver” shows up toward the bottom of the list of
controllers.
Similarly, check that the “USB-USB Network Bridge” appears toward the bottom of the [Network
adapters] list.
* If a USB Bridge icon is showing a “!” mark, this means that it was not installed correctly, and
needs to be reinstalled.
Checking the PC settings
Even if the USB Bridge software has been installed correctly, stable operation cannot be
guaranteed if the PC settings themselves are not correct.
If you think this might be the cause of problems, try checking the settings described in section 3
“Setting up the PC”.