FUJITSU NC14003-T256/L - Manual (Page 21)

20
Options
● Special cable set
Model No. Specification
High-definition monitor cable (3.0 m)
FS-C103A
Keyboard/mouse divider cable (3.0 m)
High-definition monitor cable (3.0 m)
SW2FS-C103U
USB cable (3.0 m)
FS-C103S
Audio cable (3.0m)
● Monitor conversion connector for Mac
Model No. Specification
NC14003-T044/ADP
DB15(M) < >DB15HD
Troubleshooting
Symptom Cause Action
LOW POWER LED
lights up Large power-consuming keyboards or
mice are connected. Connect the special AC adapter.
Keyboard and mouse are connected in
reverse. Correct the connection.
Cannot get out of Hot Key Mode Press the [Enter] or [ESC] key
Wrong monitor and keyboard/mouse
port Nos. Match the port Nos.
Connection/cable is defective Confirm the connector connection.
Replace with a different cable. If this
solves the problem, replace with a
new cable.
KB, Mouse is inoperable
(special type
programmable/cord-less
/ wheel mice)
A non-supported keyboard or mouse is
connected. Replace with a supported keyboard
or mouse.
Mouse not supported Replace with a supported mouse. Scroll function or buttons
do not work on the
mouse.
The specific mouse driver is not
installed. Install the specific mouse driver.
Poor screen quality
(Faded images, blurred
characters, etc.) Connection/cable is defective Confirm the connector connection.
Replace with a different cable.
Wrong resolution Adjust the resolution or use the
monitor function. Window shifts or does
not display when
switching
Unsupported monitor, or cannot
synchronize Replace with a supported monitor
(multisync).
Use the monitor function.
The DIP switches are set to OFF. Set the DIP switches on the bottom
panel to ON.
SW1: [Ctrl], [Alt] and [Shift]
simultaneously held down
SW2: [Ctrl] key pressed twice
continuously
SW3: [Scroll Lock] key pressed
twice continuously
Slow Consecutive Hot Key repeat
interval Repeat the key press slightly faster.
Cannot go into Hot Key
Mode
Hot Key operation was performed on
USB keyboard connected to HUB port. Hot Key operation is disabled as it is
enabled only on PS/2 keyboards.