Furuno NAVNET 1933C-BB - Manual (Page 20)

1-10
9. Attach connectors of the antenna cable to the locations shown in the figure below, and
then fasten a pan head screw M4x10 to fix shield cable and core case (removed at step
6.)
J801
(9 pin)
J809
(4 pin)
J810
(13 pin)
Pan head screws
M4x10 9 pcs.
Antenna unit, connector location and fixing the shield cable w/core case
10. Put the EMI core on the antenna cable into the core case attached at step 9.
The flat side of the core should face downward.
EMI core
Core case
EMI core, putting into core case
11. Refasten the shield plate and core case cover with 15 screws. Be sure that the cable
from the rotation detector passes through the notch between the two cable ties.
Mounting base
Notch
To rotation detector
How to pass the rotation detector cable