Furuno NAVNET 1933C-BB - Manual (Page 45)

3-1
3. ADJUSTMENT
3.1 How to Access the Installation Menu
Set up the equipment through the installation menu after completing the installation. To
access the installation menu, follow the steps below.
1. With the display powered off, hold down the [MENU] key. Then, momentarily press the
[POWER/TX] key while continuing to hold the [MENU] key down. You may release the
[MENU] key when a blue start-up screen appears.
2. Release the [MENU] key when the message “STARTING INSTALLATION MODE”
appears.
3. After the radar screen appears, press the [MENU] key to show the RADAR MENU.
4. Press the E: SYSTEM CONFIGURATION soft key to show the SYSTEM CONFIG menu.
SYSTEM
CONFIG
A GENERAL SETUP
B NAV OPTION
C SYSTEM SETUP
D INSTALLATION SETUP
E RETURN
Radar menu
(Ex. MODEL1823C-BB/1833C-BB/
1933C-BB/1943C-BB/1953C-BB)
System configuration menu
RADAR
MENU
A RADAR DISPLAY SETUP
B RADAR RANGE SETUP
C ARP SETUP
D FUNCTION KEY SETUP
E SYSTEM CONFIGURATION
How to access the Installation menu
5. Press the D: INSTALLATION SETUP soft key to display the INSTALL SETUP menu.
INSTALL
SETUP
A NETWORK SETUP
B RADAR SETUP
C NETWORK SOUNDER SETUP*
*: Do not change adjust items in this menu.
E RETURN
D NETWORK SETUP FOR AUX
Installation setup menu