FUJITSU fi-5750C - Manual (Page 20)

2-4
the other device. To change the SCSI ID see the
following procedure.
2.3 Installing the Scanner
Application
For scanning documents with this scanner, the
scanner driver as well as an image capturing
application software (called "application" here-
after) must be installed on your PC.
Scanner driver:
FUJITSU TWAIN 32 Scanner Driver
FUJITSU ISIS Scanner Driver
Application:
ScandAll 21 (for TWAIN)
QuickScan Pro (for ISIS)
2.3.1 For Fujitsu Twain 32
Scanner Driver
Before installing the application, please
confirm the following items:
• Keep the Setup CD-ROM at hand.
• Confirm if the scanner is connected to
your PC correctly.
• If an older version of the FUJITSU
TWAIN 32 Driver has already been
installed, please uninstall it before
installing the new one.
• There are two types of FUJITSU TWAIN
32 Drivers. Depending on the operating
system (OS) of the computer, the most
appropriate driver will be installed
automatically.
• For Windows 98, Windows Me,
Windows 2000, Windows XP:
FUJITSU TWAIN32 V9
• For Windows 95 and Windows
NT 4.0:
FUJITSU TWAIN32 V8
• When using Windows 95 or Windows
NT 4.0: ASPI Manager 4.01 or later is
required (generally comes with SCSI
board products).
1. Turn the scanner OFF.
2. Set the SCSI ID.
Set the device address by using the SCSI
ID switch on the rear of the scanner.
TABLE 1.
No. Description:
0 - 7 Can be set as the ID.
8, 9 Used for the factory default value
(SCSI ID=5).
3. Turn ON the Scanner.
When the scanner is turned ON, the SCSI
ID set at step 2 is enabled.
4. Turn ON your PC.
Preparation
HINT
For details on connecting the scanner,
refer to "2.1 Installing the scanner" on
page 2 in this manual.
ATTENTION
Uninstall [Scanner Utility for Microsoft
Windows] in [Add/Remove Programs] of
the control panel.