FUJITSU fi-5750C - Manual (Page 33)

AP-3
The printed scanned
image shifts or is dis-
torted.
Are the documents loaded
correctly?
Load the documents correctly.
Quality of scanned
images is unsatisfac-
tory.
(When using the Flatbed)
Is the document holding pad
dirty?
Install the document holding pad correctly.
(When using the ADF)
Is the glass inside the ADF dirty?
Clean the glass following the instruction in “4.2
Cleaning ADF” of the “fi-5750C Operator’s
Guide”.
Double feeds occur fre-
quently.
Do the documents qualify the
"Document Quality" and "Double-
feed Detection Condition" in "8
DOCUMENT SPECIFICATON
FOR THE ADF" of the "fi-5750C
Operator's Guide" fi-5750C?
Use the documents that qualify the "Document
Quality" and "Double-feed Detection Condition"
in "8 DOCUMENT SPECIFICATON FOR THE
ADF" of the "fi-5750C Operator's Guide".
Are the documents set properly on
the ADF paper chute?
Fan the documents before scanning. Correctly
align the document stack and load them on the
ADF paper chute. For details, refer to "2 BASIC
SCANNER OPERATIONS" of the "fi-5750C
Operator's Guide".
Is the document stack thicker
than: 20mm? (for A4 size paper)
10mm? (for A3 size paper)
Reduce the number of sheets in the document
stack to 20mm (for A4 size paper) or 10mm (for
A3 size paper) thickness or less.
Is the Brake roller dirty? Clean the Brake roller. For details, refer to "4
DAILY CARE OF THE EQUIPMENT" of the "fi-
5750C Operator's Guide"
Is the Brake roller worn out? Replace the Brake roller. For details, refer to "5
REPLACING CONSUMABLES" of the "fi-
5750C Operator's Guide"
Documents are not fed
into the ADF (pick
error occurs frequently
or the document stops
midway).
Do the documents qualify the
"Document Quality" and "Double-
feed Detection Condition" in "8
DOCUMENT SPECIFICATON
FOR THE ADF" of the "fi-5750C
Operator's Guide"?
Use the documents that qualify the "Document
Quality" and "Double-feed Detection Condition"
in "8 DOCUMENT SPECIFICATON FOR THE
ADF" of the "fi-5750C Operator's Guide".
Is the Pick roller set dirty? Clean the Pick roller set. For details, refer to 4.2
"Cleaning the ADF" of the "fi-5750C Operator's
Guide".
Is the Pick roller set worn? Replace the Pick roller set. For details, refer to 5.3
"Replacing the pick roller set" of the "fi-5750C
Operator's Guide".
Is there any debris on the
document feed path?
Remove any debris from the document feed path.
The scanned images are
elongated.
Are the Feed rollers dirty? Clean the Feed rollers. For details, refer to the "fi-
5750C Operator's Guide".
Did you adjust the scan scale? For Windows 98, Windows Me, Windows 2000
and Windows XP, please select [Scanner and
Camera] in the [Control Panel], then click [Device
Set] tab to adjust the scan scale.
For Windows 95 and Windows NT 4.0, right-click
Scanner Control Center icon in task tray, select
[Option] and adjust the scan scale. Please refer to
“7 Online Setup” of the “fi-5750 Operator's
Guide” and adjust the offset from the Software
Operation Panel (online settings).
TABLE 1.
Symptom Check this Item Remedy