FUJITSU fi-5750C - Manual (Page 8)

vi
CAUTION
The following describes important cautions
described in this manual.
Do not put liquids inside the scanner.
Do not insert or drop metal
objects in to the scanner.
Do not scan wet documents or
documents with paper clips or
staples.
Do not splash or allow the scan-
ner to get wet.
If foreign objects (water, small
metal objects, liquids, etc.) get
inside the scanner, immediately
turn off the scanner and
disconnect the power plug from
the power outlet, then contact
the store where you bought the
scanner or the Maintenance
Service Center.
Pay particular attention to this
warning in households where
there are small children.
Do not touch the inside of the
scanner unless necessary.
Do not take apart or modify the
scanner. The inside of the
scanner contains high-voltage
components. Touching these
components might cause fire or
electric shock.
Do not install the scanner on unsta-
ble surfaces.
Install the scanner on a desk so
that none of its parts protrude
outside of the desktop. Also,
make sure that the scanner is
installed on a flat, level surface.
Do not install the scanner on
unstable surfaces. Install the
scanner on a level surface that is
free of vibration to prevent it
from falling.
Install the scanner on a strong
surface that will support the
weight of the scanner and other
devices.
Firmly insert the power plug.
Firmly insert the power plug into
the power outlet as far it can go.
Do not block the ventilation ports.
Do not block the ventilation
ports. Blocking the ventilation
ports generates heat inside of
scanner, which may results in
fire or scanner failure.
Do not place heavy objects or climb
on top of the scanner.
Do not place heavy objects on
the scanner or use the scanner's
top surface for performing other
work. Improper installation
might cause injuries.
Before moving the scanner,
disconnect the power plug from the
power outlet.
Do not move the scanner with
the power and interface cables
connected as this might damage
the cables, causing fire, electric
shock or injuries.
Before moving the scanner, be
sure to disconnect the power
plug from the power outlet, and
disconnect data cables. Also,
make sure that the floor is free of
obstructions.
Do not use the scanner immediately
after moving it from a cold place into
a warm room.
Do not use the device immedi-
ately after moving it from a cold
place into a warm room. This
may cause condensation, which
might lead to scanning errors.
Let the device dry about one or
two hours before you use it.