FUJITSU fi-5750C - Manual (Page 21)

2-5
Installing the FUJITSU
TWAIN32 Scanner Driver
HINT
Windows XP screenshots are used in this
section. The windows and operations
may slightly vary depending on your OS.
1. Turn the scanner ON.
2. Turn on your PC and log on to
Windows.
ATTENTION
When using Windows NT 4.0, Windows
2000 or Windows XP, log on as a user
with "Administrator" privileges (privileges
of the administrator of your PC)
HINT
The scanner may be detected
automatically. If so, [Found New
Hardware Wizard] (or [Add/Remove
Hardware Wizard]) dialog box will
appear. Click [Cancel] to close the
Wizard window.
3. Insert the Setup CD-ROM into the CD
drive.
The <SETUP DISK START UP SCREEN>
will be displayed.
ATTENTION
This screen may not appear when the
"Autoplay" setting of your PC is OFF. In
this case, run "Install.exe" in this CD-
ROM directly by the "Explorer" or "My
Computer".
4. Click [Install Products].
5. Click [TWAIN Driver] on the window
below.
6. Error Recovery Guide Installation win-
dow appears.
Error Recovery Guide is a software that
displays troubleshooting information on
screen if any scanner error occurred.
Although you do not install this software,
the performance of the scanner would not
be affected. However it is recommendable
to install this software.
ATTENTION
When you select [Yes] for installing Error
Recovery Guide, [Choose Setup
Language] window appears. Select a
language and follow the instructions on
the window. Error Recovery Guide will
automatically start on finishing its
installation. Please wait until the
installation of TWAIN driver automatically
starts.