FieldServer Carrier DataPort FS-8700-86 - Manual (Page 20)

FS-8700-86 Carrier DataPort Page 20 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
In the following two examples the keywords that are not recognized are 'Reset T' and 'Tripout'
respectively
CarrDP:#24 Err. MD=<MapDesc1> discrete state word not recognized.
T02> <MODE Reset T 000 000 Control Mode
>
T02> CarrDP:#24 Err. MD=<MapDesc1> discrete state word not recognized.
T02> <STATUS Tripout 000 000 Run Status
>
In the following example the keyword '********' is not being recognized. If this message is printed
it is necessary to consult Carrier Corp. to learn why a variables’ value is printed as '********'. It
may be that the value is over range or invalid.
T02> CarrDP:#24 Err. MD=<MapDesc1> discrete state word not recognized.
T02> <CHWPD ********** 020 000 Chilled Water Delta P
>
T02>
Extending the List of Discrete State Words
You can extend the list of state words the driver recognizes by modifying the configuration CSV
file.
The following example adds three state words. If a device reports the state of the variable as
LIGHT then the driver will store the value of 1, if on the other hand the state is reported as DARK
then the driver will store the value zero.
Driver_Table
Carrier_Attr_State_Name, Carrier_Attr_State_Value, Protocol
LIGHT , 1 , CarrierDP
DARK , 0 , CarrierDP
This method may be used to change the values of any of the driver’s default state words by
duplicating the word and specifying a new value in the configuration file.
Appendix A.4.2. Time Values
If the driver receives a variable value reported in the format hh:mm then the driver stores a
number obtained by multiplying the hours by 60 and adding the minutes. The driver recognizes a
time value by checking the 3
rd character for a colon and checking that the 1 st character is a digit.
Value_Stored = hh * 60 + mm
E.g. 5:30pm is reported as 17:20 and is stored as 17*60 + 20 = 1040.
Protocol must
be defined on
every line.
Keyword
starts a new
section
of
the CSV file.
State Words
The name will be
stripped of all
spaces between the
last character and
the comma.
Normally the values
will be 1/0 for the
on/off states but the
driver
does not
restrict the value.