FieldServer Carrier DataPort FS-8700-86 - Manual (Page 30)

FS-8700-86 Carrier DataPort Page 30 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Error Message Explanation
CarrDP:#33 Err. DataPort
responded
with Err=%d.
Device=%s
There DataPort device responded but the response reports an error. The
error number is printed in the message. The message also reports the
name of the node that was polled.
The following 6 errors are documented. For other errors contact the
Carrier Vendor.
#1 Invalid Command : The digit 1 returned as an error code means that
the last ASCII character sent to the DATAPORT by the off-network
device is not one that the DATAPORT recognizes as a command.
#2 No Display Table : The digit 2 returned as an error code means that
the off-network device has commanded the DATAPORT to transmit data
from a controller that is properly configured in the DATAPORT, but the
controller does not contain a point display table.
#3 CCN Bus Communication Error: The digit 3 returned as an error code
means that the DATAPORT cannot transmit data from the requested
controller because a communication error occurred while the
DATAPORT was acquiring data from that controller.
#4 Database Full : The digit 4 returned as an error code means that the
off-network device has commanded the DATAPORT to transmit data
from a controller that is properly configured in the DATAPORT, but the
controller is beyond the 900 point limit. For example, if controllers 1
through 10 each contain 90 points, a command for the DATAPORT to
transmit data from controller 11, 12, 13, 14, or 15 will result in error code
4.
#5 DATAPORT Busy : The digit 5 returned as an error code means that
a static data update is in progress, preventing the DATAPORT from
responding successfully to a Send Controller Data Command or a Send
Data Periodically command.
#6 Controller Not Configured : The digit 6 returned as an error code
means that the off-network device has commanded the DATAPORT to
transmit data from a controller that is not configured in the DATAPORT.
For example, if only controllers 1 through 5 are configured in the
DATAPORT, a command of 0 (Send Controller Data for Controller 15)
will result in error code 6.
CarrDP:#99 Err. Cant open
INI file for response. This message should only be printed in simulation mode (QA testing). If
you see this message call Tech Support.