Frymaster FMCFE - Manual (Page 18)

MASTER JET CF SERIES ATMOSPHERIC GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-13
1.8.6 Replacing Heat Mode Indicator Light – Operating Thermostat Controls
1. Disconnect the fryer from the electrical supply.
2. Loosen the setscrew securing the thermostat knob and remove the knob. Remove the screws
from the upper left and right corners of the control panel. The control panel is hinged at the
bottom and will swing open from the top.
3. Disconnect the 9-pin connector and remove the control panel from the fryer by disengaging its
tabs from the hinge slots in the mounting frame.
4. Carefully press the light out from the back of the control panel. Disconnect one wire at a time
and reconnect it to the replacement light until all wires are transferred.
5. Carefully press the light back into the control panel.
6. Reverse steps 1-3 to reassemble the fryer.
1.8.7 Replacing Power/Melt Cycle Switch – Operating Thermostat Controls
NOTE: The Power/Melt-Cycle Switch, P/N 807-1404, has been replaced with a new switch, P/N
807-3498. When ordering the new switch, order Kit 826-1792, which contains the new switch and
wiring instructions. The new switch is wired differently than the old one. Ensure the new switch is
wired properly before operating fryer. Consult P/N 819-5889 (MJCF, MJ45 Switch Replacement
Instructions) for further detail.
1. Disconnect the fryer from the electrical supply.
2. Loosen the setscrew securing the thermostat knob and remove the knob. Remove the screws
from the upper left and right corners of the control panel. The control panel is hinged at the
bottom and will swing open from the top.
3. Disconnect the 9-pin connector and remove the control panel from the fryer by disengaging its
tabs from the hinge slots in the mounting frame.
4. Using a flat-tipped screwdriver, disconnect the chrome bezel from the tabs on the switch and
press the switch out from the front.
5. Carefully press the new switch back into the chrome bezel, ensuring the tabs on the switch
engage the slots in the bezel.
6. Disconnect the wires from the old switch and reconnect to the new switch until all wires have
been transferred (see note at the beginning of this procedure).
7. Reverse steps 1-3 to reassemble the fryer.