Connecting to a switch, hub, pc, or server, Connecting to a switch, hub, pc, or server -2 – Foundry Networks IRONPOINT 250 User Manual
Page 40
Advertising
Foundry IronPoint 250 Installation Guide
5-2
© 2007 Foundry Networks, Inc.
August 2007
Connecting to a Switch, Hub, PC, or Server
1. Attach one end of a twisted-pair cable segment to the network device’s RJ-45 connector.
Figure 5-1. Connecting to a Network Device
2. Attach the other end of the cable segment to the Ethernet port on the access point.
Note: Make sure the twisted pair cable does not exceed 100 meters (328 ft) in length.
3. As the connection is made, the access point’s Link LED should light indicating a valid network
connection. If the Link LED fails to light, see Appendix A for troubleshooting information.
Advertising