Frymaster 8196606 - Manual (Page 6)

Cabinet Service Procedures
2-1
2 Service Procedures
DANGER: Failure to disconnect power from the unit before servicing could result in serious
injury or death. The cabinet power switch DOES NOT disconnect all incoming power to the
cabinet.
2.1 Updating Software/Capturing Configurations
The five sections of software on the cabinet can be updated individually. To ensure compatibility between cabinet
software and replacement boards, the software should be updated to the latest version at any board replacement. Follow
the directions below.
Software updates use the master control display to enter programming codes, scroll to areas to be revised, respond to
questions and exit. The control is annotated above. The arrow and OK buttons are illuminated when active.
Check Existing Versions
1. With the unit powered up, press the programming key.
2. Screen scrolls Enter Access Sequence.
3. Enter 090809 on keypad.
4. Press
OK.
5. Scroll with arrow keys to view all software revision numbers:
• Main
• Boot
Loader
• Master
Display
• Distribution
Board
• Row
Display
6. Press OK.
Fig. 1: The sides
are held in place
by screws near
the base of the
unit on each side.
Fig. 2: Tabs in the topcap extend to
holes in the cabinet. The top is secured
with at the tabs with screws.
Programming key:
Press prior to entering
programming code.
OK: Press to confirm
choices. Arrows: Scroll to
choices.
Power Switch: Cycle
power between each
revision update.
Keypad: Enter
programming
d
NOTE: If the master control
displays an error message
during the install process, turn
the cabinet off for 30 seconds
and back on. Repeat install
steps.